Follow the curved or straight shaft instructions first then follow the ones below when prompted.
- 4. Remove the 3 screws from the top of the head. Do not lose the plastic line holders as they will be needed later.
- 5. Remove the triangular top from the head (may need a flat screwdriver to pry it off). Drop the nut or bolt you found in step 3 of the straight/curved shaft installation in the hex shaped recessed hole located on the underside of the triangular top. The threaded end of the bolt goes in first.
- 6. Resinstall the top of the head onto the body. Slide the plastic line holders onto the screws before threading back into the head. Screw the head onto the shaft of your trimmer.
Copyright © CMD Products All Rights Reserved